DT125R ARCHIVE

rmbukk · DTR Member

Smaller front spocket and front sticker above headlight....

AndyA · DTR Member

I think the standard sprocket is 16 tooth, I have put a 15 tooth sprocket on my wifes bike shaves a little off the top end but gives better low down pull, good if you want to do a bit of off road work as well 1 tooth on the front is more or less the same as 3 teeth on the rear sprocket, my wifes bike is 15 - 50, you should be able to order one from any good bike shop.
Motoward is a Yamaha specialist try them for spocket and sticker, here is a link to the web sight. biggrin

http://www.motoward.co.uk/

-- Edited by AndyA at 00:27, 2009-02-23

Gixergav · DTR Senior Member

If i remember right the standard sizes for a dt (88-04) is 16-57
Personally i tend to adjust sprocket sizes on the rear first as it gives the output shaft and its bearing an easier time.
One tooth less on the front will definitly give the bike a boost in acceleration and an easier time pulling wheelies.Probably knock 5-10mph off top speed.

SimsonS51E · Guru

rmbukk wrote:

Secondly could someone show me where to get the white sticker that goes above the front headlight? I think it only came on the older DTs and didnt come on the 04's onwards?

Thanks in advance

White Sticker ??
I think your on about the white number board thing ??
5" high by 9" Wide ??

They do come on the later models, in different colours [white on blue bikes etc ]

Yammy will cost daft money, but if you wan't factory look ?
Or a couple of lads on here do graphics ! and will knock one up if you measure size / shape ..