personal customization aint it m8 ,, you put your own mark onit,,, all you put in to it just makes you prouder off your machine when you stand back an look at it .
I've used that same little LED numberplate light on mine. I started off with an enduro LED tail/brake light and number plate holder that I got off Ebay for about £20, and cut it down and drilled and mounted it to the rear sub=frame under the fender, then I drilled and mounted the number plate light just above the plate. It looks amazing in the dark as the original brake and tail light work at the same time as the the new LED unit (double tail ligfhts and brake lights). And that little LED numberplate light illuminates the whole road behind you. I'll put up a night shot of mine when I get my bike put back together in next couple of days!
__________________
Is that bits of piston ring firing out your tailpipe?
I thought they were needed for MOT too, didn't check that with the MOT centre before fitting though, just assumed you'd need them so the old bill can see your plate. Definitely do need the reflector for the MOT though, i stuck a bicycle one on my plate for MOT. I think you can get reflective strip tape stuff and just put a little strip along top or bottom of your plate
__________________
Is that bits of piston ring firing out your tailpipe?
hmmm well i had to make my own tail tidy and i managed to keep origanl no plate light lol...but dropped my bike and now it falls off when i go over a bump...so u sure u dont need one cos ill lose it if so!
Although the reflection of the absolute need to MOT, I adhere to the one for me one of the bike MOT board. I think you can reflective strips things, just put your plate in a small strip along the top or bottom of the..
