i have a v reg dtr, had framepowder coated n decided to put yz front end on, i stripped my bike and got a bearing made for the bottom yoak, tryed puttin the yoaks on, AND ON THE OLD DT THE IS A LINER THAT HOLDS THE BEARINGS IN, WELL THE YZ YOAK TUBE WAS SLIGHTLY TO FAT TO FIT THREW, I DI TRY TO DRILL I BUT DIDNT GET ANYWERE, SO I HAD TO SMASH IT OUT, DOES ANY1 NO THE SIZE OF THE WHOLE IN MY FRAME SO I CUD GET A BEARING FROM OR ANY1 GOT ANY IDEAS?
i do acculy have them fitted to my bike, witch i use daily, but the top bearing i have on is the original yz 1 and differant n just sittin on -to high, need to strip it down rel n go get a propa bearin made
thanks for reply, i need the thing for my frame that the bearings sit on, as i ad to smash it off to fit my fat forks on, just woundered if any1 kne the messurement of the stem of the dt so i cud get 1 made with striping it all 1st,
I fitted Husky CR125 forks, I pressed the original yoke tube out of it, then pressed DT tube out and switched the tubes so I could use the original bearings. The yoke tube diameter in the point which sits in the yoke was 40mm in both yokes if I remember it right and DT tube was a straight fit.
