Just noticed that the wr 250/450f frames are very similar to the dts especially the dtre. Apart from they have different subframes (seperate part) the actual frame looks similar and i just looked at some full yokes on ebay from a wr450 and they look very similar to the dt's?!?!
Just wondering if the USD's from a wr would fit a dt without mods?
they may fit if the roller bearing down there is the same but if wr has a roller bearing on top, and dt has a ball bearing on top, they probably wont go straight on.
my set up is off a 450 not sure of the year but they almost looked like a straight fit, but the stem was too long and it wouldnt go through the top hole on the frame when fitting, its not as hard to convert as you may think
my set up is off a 450 not sure of the year but they almost looked like a straight fit, but the stem was too long and it wouldnt go through the top hole on the frame when fitting, its not as hard to convert as you may think
