DT125R ARCHIVE

madrevs · DTR Senior Member

mixture screw

carl13671 · DTR Senior Member

Should go in alot further mate,the bottom o-ring needs to seal properly

madrevs · DTR Senior Member

Hmmm might have to get another carb afterall its annoying cos old one screwed out easily with a small drill hole and a star bit

madrevs · DTR Senior Member

Bit of a update have bought a empty carb off a member hopefully will be coming tuesday and a new 240 main jet aswell.

madrevs · DTR Senior Member

Other carb deal fell through have got the new mixture screw and it seems to be turning in alot moree now could someone post a pic of there mixture screw screwed into the carb recess so I can see if my screw goes in far enough.thanks

madrevs · DTR Senior Member

Might be better if I post a pic.this is the screw screwed all the way in.is this normal or should it go in further any help greatly appreciated.

Thanks

-- Edited by madrevs on Thursday 16th of January 2014 08:39:04 PM

carl13671 · DTR Senior Member

Looks good to me mate.

MDK · DTR Legend

the top of that screw also looks bit batter and you could end up the same problem again .

take it out and neaten up the notch with hacksaw and use a correct size and fatness screwdriver

madrevs · DTR Senior Member

Thanks for the advice however bought another carb in the end as had enough of fiddling about with it might still fit the plate to my old carb and put it on ebay or keep as spares