Right i've got a full dep, followed the instructions in the haynes manual for setting the powervalve up, and the reed switch dangling down behind the head light why cant i go over 65 ??? it gets to 65mph at 8k revs and thats it wont go anymore without a hill :( anybody know why?
yes that the switch mate get sum black tape around it and tuck it away
__________________
it worked better in my head so many things do i don't understand..................2000 husqvarna sm125s.....SOLD....2009 ktm 125sx.....2002 yamaha dtr125sm project....SOLD......cagiva super city 125 project
tape will just stop the water getting in mate thats all.....
__________________
it worked better in my head so many things do i don't understand..................2000 husqvarna sm125s.....SOLD....2009 ktm 125sx.....2002 yamaha dtr125sm project....SOLD......cagiva super city 125 project
The speed is restricted by means of a reed switch which is mounted in the rear of the speedo. It tells the CDI when the bike reaches 60mph and stops the revs from increasing. To remove the speedo restriction take off the headlamp cowl and pull out the spring clips holding the speedo in. Then unscrew the speedo cable and lift up the clock. You will see two things in the bottom of the clock casing. One is round and is the light bulb for the clock, the other is white and oblong. This is the reed switch and you carefully prise it out and tuck it to one side out of the clock. I suggest you put it in a bag and tuck it as far away as possible. Do not cut or disconnect it.
