DT125R ARCHIVE

Members Login
Username 
 
Password 
    Remember Me  
DT125R Forum -> HEAD STOCK -> Getting lower yoke ready for powder coating problem
Post Info TOPIC: Getting lower yoke ready for powder coating problem
slob


Guru

Status: Offline
Posts: 849
Date:
Getting lower yoke ready for powder coating problem
Permalink  
 

I have every thing ready for going away to the coaters. However I am stuck as to how I am going to remove first of all the bearing on the stem. Also how I am going to separate the stem from the yoke. I was hoping to get the stuff to the shop tomorrow bit thus is looking unlikely. Unless I can get the bottom yoke free. Thanks Slob

__________________
Calum122


Guru

Status: Offline
Posts: 7569
Date:
Permalink  
 

The stem needs to be pressed out using an Hydrolic press.

__________________

Always Originate, Never Pirate!

The Leviathan Project
Calum122


Guru

Status: Offline
Posts: 7569
Date:
Permalink  
 

Not sure about the bearin sorry.

__________________

Always Originate, Never Pirate!

The Leviathan Project
slob


Guru

Status: Offline
Posts: 849
Date:
Permalink  
 

cheers callum. I am going to cut the bearing with a dremmel, seen it on you tube. As for the press i don't know what I will do.

__________________
Calum122


Guru

Status: Offline
Posts: 7569
Date:
Permalink  
 

Yeah. Someone on here just said about getting the bearing off. They sounded like they had a similar problem.

A local garage should have a press mate. Could just go in and ask. Shouldn't cost you much. 5er for doing it my guess.

__________________

Always Originate, Never Pirate!

The Leviathan Project
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.
DT125R Forum -> HEAD STOCK -> Getting lower yoke ready for powder coating problem
Tweet this page Post to Digg Post to Del.icio.us


Create your own FREE Forum
Report Abuse 		Powered by ActiveBoard