DT125R ARCHIVE

Boxing wrote:

---

No thread for the CR 80? :(

I have a project KX 100 and KX 80 2000 (Going to be a donor for its bottom end though) would be nice to see your CR project. :)

Also same story with my projects, want to finish them but money comes in slow. :(

-- Edited by Boxing on Thursday 26th of December 2013 05:07:57 AM

---

 ill start a thread once some more progress happens with it. the frame is currently at the powder coaters just got to go pick it up. its getting all new bearings through out. and full plastic set, new chain and sprockets, engine is ok piston is a bit scored down the exhaust port side but compression is gd, ill jus run it still tht piston is proper killed. wheels have been rebuilt and repaired as alot of the spokes wer loose and some wer missing, wheels bearings wer shagged aswell, both calipers and carriers have been cleaned and sand blasted, just got to hammerite them in silver again and new pistion and seal kits, thats pretty much it not alot to these lil mxers took only about an hour or so to fully strip it and dig out all the old bearings all on the frame and rear suspension, pics will follow soonish