DT125R ARCHIVE

DTRE/X Kick Start Conversion This is a tutorial for future reference for anyone who is thinking of or is going to carry out a kick start conversion for their DT125RE. This may also help if you are going to dismantle the clutch to replace/inspect or repair. It may also help if you wish to replace the ki...

So I was having an argument with my friend. We always argue and I swear each and everytime we argue he is ALWAYS right! I'm only arguing because what he says is just so out of the ordinary. Anyway... He reckons that an RD350 engine should fit in a DT frame with a none or a little bit of modification to the fra...

Hello, Just got back from the engineers. I know I've told many about my plans for the Upside Down Fork conversion cause I've been asking a lot of questions. Since I decided not to grind the stem down I have instead gone the other way. I'm using the original Tapered bearings to install the Yokes. To do thi...

	Forum	Replies	Views	Last Post
Kick Start Conversion RE 125 DT Idle Clutch Maintenance Circlips Thrust Washer Bolts Stainless Steel Nut Help Tutorial Modifications Upgrade How to DT125RE/X Kick Start Conversion Tutorial (Preview)	KICKSTARTS	7	15061	Mar 12, 2012 by xGINCATx
DTRE/X Kick Start Conversion This is a tutorial for future reference for anyone who is thinking of or is going to carry out a kick start conversion for their DT125RE. This may also help if you are going to dismantle the clutch to replace/inspect or repair. It may also help if you wish to replace the ki...
Rd 350 DT Conversion Swap RD350 Engine (Preview)	Tuning	9	1892	Jun 24, 2012 by Power valve kid
So I was having an argument with my friend. We always argue and I swear each and everytime we argue he is ALWAYS right! I'm only arguing because what he says is just so out of the ordinary. Anyway... He reckons that an RD350 engine should fit in a DT frame with a none or a little bit of modification to the fra...
USD How To Conversion Properly Yamaha WR250F USD Conversion Using an Extension ( 1 2 ) (Preview)	FORKS	56	5358	Jun 12, 2013 by Calum122
Hello, Just got back from the engineers. I know I've told many about my plans for the Upside Down Fork conversion cause I've been asking a lot of questions. Since I decided not to grind the stem down I have instead gone the other way. I'm using the original Tapered bearings to install the Yokes. To do thi...